The fuel-air mixture formed in the intake tract requires a certain period of time until is reaches the oxygen sensor in the form of exhaust gas. This time decreases as load and engine speed increase. For this reason, the response time of the emission (lambda) control system is also dependent on load and engine speed.Fuel-air mixture deviations detected by the oxygen sensor result in adaptation values (learned correction values) being stored. By way of the adaptations, the injection can be brought close to the nominal value in advance. A reduction in the response time is achieved in this way.
For instance, if the basic injection values of the DME characteristic map are too low during idling or in order to maintain the ideal fuel-air mixture, the emission (lambda) control system would have to constantly increase the injection timing. In this case, an adaptation value is learnt which corrects the basic injection value. The emission (lambda) control then only needs to undertake the fine adjustment.
Following adaptations are performed during engine operation:
When the tank ventilation valve is open, an additional combustible mixture is supplied from the activated carbon filter to the engine.The shift in the air-fuel ration detected by the oxygen sensor is almost completely compensated by means of the tank ventilation adaptation value.
The task of idle air adaptation is carried out by the idle actuator.On the basis of the air volume it ensures a constant idle speed.
If idling is detected on the basis of the throttle position during the rest phase of the tank ventilation system, idle mixture adaptation takes place at certain intervals.
Also in the partial load range, mixture adaptation takes place at certain intervals.The determined adaptation value is taken into consideration in all partial load ranges.