The power windows are operated by means of the control switches integrated in the door modules and by the switches in the rear doors.
The switches in the rear doors signal the switch status via two lines to the general module (ground signal). The door module for the driver's door, via which all windows can be operated, sends its data via the "P-bus" to the general module and the door module of the front passenger's door.
All switches feature two switch stages. The window is opened or closed by lightly pressing or pulling back the switch. On releasing the switch the power window drive is switched off immediately.
The second switch stage is activated by pressing or pulling beyond the first stage. The power window drive is now in automatic mode and is operated until the window is completely opened or closed. Automatic mode is cancelled by operating the switch once again.
Due to legal stipulations, automatic mode is dependent on coded data. Example: In the Australia variant automatic mode in "close" direction is only possible on the driver's door.
In automatic mode, the drive is switched off by way of current measurement. On reaching the end position, the drive is blocked temporarily thus resulting in an increase in the power intake. This increase in power intake is detected in the door module (front windows) or in the rear module (rear windows) and the drive is switched off.
A finger-trap protection strip is installed at the top of all door window frames. This strip consists of two contact strips enclosed in plastic which make an electrically conductive connection when pressure is applied.
If pressure is applied to the finger-trap protection strip while closing the window, the closing function is interrupted and the window is driven in open direction for approx. 1-2 seconds.
When pressure is applied permanently to the finger-trap protection strip, the window can only be closed in switch position 2 (pulling) (switch position automatic).
The finger-trap protection strips are monitored for line failure by means of a resistor connected in parallel. If a break occurs, the window can also only be closed by pressing the switch to automatic position.
The windows and sunroof can be opened and closed via the lock cylinder in the driver's door and by means of remote control.
Convenient opening takes place when the lock cylinder is held in the "unlock" position for longer than 3 seconds or when the corresponding button on the remote control is pressed and held.
Convenient closing takes place when the lock cylinder is held in the "lock" position for longer than 2 seconds or when the corresponding button on the remote control is pressed and held.
The functions can be activated or deactivated by encoding.
The power windows are active when terminal R is switched on. Initially, the power windows are still operable after switching off terminal R. Automatic cut-out (deactivation) takes place after 16 minutes.
Depending on legal stipulations in the relevant country, the power windows are additionally deactivated by opening the driver's or passenger's door.
Two different versions are codeable:
ECE version |
Deactivation after switching off terminal R and opening and closing the driver's or passenger's door. |
USA and Australia |
Deactivation after switching off terminal R and opening the driver's or passenger's door. |
These cutout (deactivation) conditions also apply to the sunroof.