Dynamic Stability Control DSC8

The E60 is fitted with Dynamic Stability Control DSC8. In comparison with the previous system DSC5.7 in the E65, most of the hardware has been revised.

Functional description, see BMW Service Technology:

TIS -> Document -> SI Technology -> Enter SBT Number

SBT number:

• 34 02 03 042
  

Diagnosis instructions

Remedying faults and/or deleting the fault code memory

If problems occur on deleting the fault code memory following a repair, use the following procedure:

1. Remedy fault with ignition off
   
2. Ignition on; delete fault code memory
   
3. Switch off ignition: wait 5 - 10 seconds, switch ignition on again.
   
4. Delete fault code memory again
   

Important:

In some cases, indicator and warning lamps for certain faults only go out after a short test drive.