Information is shown in the testing device. Display in the Control Display is not possible.
The controller can be used to activate Service mode. The Service mode provides access to details of the hardware/software versions for the Control Display and the control units in the MOST network, for example. Service mode provides a simple means of quickly accessing diagnostic data without the need for a diagnosis tester.
Activating Service mode:
1. With the basic menu active, press and hold down the Controller for at least 10 seconds.
2. Turn Controller three increments clockwise
3. Turn controller three increments anti-clockwise
4. Turn Controller one increment clockwise
5. Turn Controller one increment anti-clockwise
6. Turn Controller one increment clockwise
7. Press Controller down.
The function ”MOST devices” provides a list of all nodes in the MOST network. When a control unit is selected, a scrollable list detailing the following information appears: Item number, hardware number, coding index, diagnosis index, variant index, date of manufacture, manufacturer, message catalogue version, software and operating system version.
If the information is displayed correctly, the control unit software is working. If incorrect or no data of a control unit is stored but the MOST framework is working, there is a software error in the corresponding control unit. The control unit no longer functions.
Display |
Setpoint |
If not OK, carry out the following test |
1 |
Rest impulse of 0 or 1, the number of impulses increases depending on the wheel speed |
Wheel speed sensor |
2 |
With unobstructed upward field of vision: >2 |
GPS |
3 |
Clear upward field of vision: Position known, satellite search, satellite contact. |
Initialisation of navigation, GPS |
4 |
Direction arrow in the Control Display clearly moves out of zero position when turning off. Check in control unit functions: In resting position 2500 mV+/-400 mV;move navigation computer, voltage must change |
If value is not OK: replace navigation computer. |
5 |
Check in control unit functions. |
Reverse |
Definition GPS status
GPS status |
Definition |
GPS fault |
GPS inoperable |
Reception interference |
GPS receiver/aerial |
No almanac |
No data has yet been stored by satellites, initialize navigation |
Satellite search |
GPS searches for satellites |
Satellite contact |
At least 1 satellite found |
Position known |
Degrees latitude and longitude determined (navigation function possible). |
Meaning of almanac: After applying supply voltage terminal 30, terminal R and making satellite contact, data from satellites is collected and stored in the GPS receiver. If this data is not available, e.g. after disconnecting battery or GPS receiver, the vehicle must be parked outside with unobstructed upward field of vision and terminal R switched on (approx. 15 minutes).