To calibrate the back-up camera, the lines shown in the picture must be brought into the right position on the target. The calibration requires a defined vehicle status.
On calibration, the full screen mode is activated automatically!
Secure the target to the rear axle as described in the repair instruction.
Step 1: Correct the distortion. To do so, turn the lines until they are parallel to the circles on the target.
Step 2:Shift the vertical lines on the x-axis. Shift the lines to the left or right until they pass through the four circles. In the example below, the lines must be shifted to the left.
Step 3:The horizontal line on the y-axis. Move the line upwards or downwards until the intersecting points are at the vertical lines in the upper circles. In the graphic below, the line must be shifted downwards.
At the end of the calibration, the lines must pass through the centre of the circles. The optimised alignment of the lines is achieved when the inner areas of the circles show through around the lines. The set calibration values are adopted into the camera on confirmation.
