Panorama glass sunroof (SHD)

Functional description, see BMW Technology:

TIS -> Document -> SI Technology -> 61 12 03055

Initialisation

The initialisation procedure is divided into the functions 'Standardization' and 'Learning the characteristic curve'.

• During standardisation, the end stop of the panorama glass sunroof with sliding panel towards ”Lift” is learned. The control unit for the panorama glass sunroof uses this to calculate the end stops for opening and closing.
  

• When the characteristic curve is learned, the mechanical closing forces in the panorama glass sunroof are recorded.
  

Important!

During the entire operation, the anti-trapping mechanism is not active!

Sequence of the initialisation

Press the operating switch for the panorama glass sunroof to ”Lift” and hold it there. After approx. 15 seconds, the operation starts automatically. The initialisation runs as follows:

1. Panorama glass sunroof is lifted
   
2. Sliding panel opens completely
   
3. Sliding panel closes completely
   
4. Sliding panel opens again completely
   
5. Panorama glass sunroof is lowered
   
6. Panorama glass sunroof opens completely
   
7. Panorama glass sunroof closes completely
   

The entire operation takes approx. 75 seconds. The switch for the panorama glass sunroof must be kept pressed during the initialisation. If the panorama glass sunroof switch is released, the procedure must be repeated.

After the panorama glass sunroof has closed again, the switch can be released. After approx. 5 seconds, which is required for data storage, all the functions of the panorama glass sunroof can once again be operated using the switch.

Important

Re-initialisation will be necessary after conducting repairs on the panorama sunroof.

Note: If the sunroof stops before reaching the end position, keep the switch pressed and wait for at least 15 seconds (deletion of initialization values). The sunroof then continues to move. Keep the switch pressed for 1 second when the sunroof reaches the end position.