| Number | X-pin, color | Description |
|---|---|---|
| X60201 | 9-pin, Gray | Connector Engine control module II (DME) Module 1 |
| X60202 | 24-pin, Gray | Connector Engine control module II (DME) Module 2 |
| X60203 | 52-pin, Gray | Connector Engine control module II (DME) Module 3 |
| X60204 | 40-pin, Gray | Connector Engine control module II (DME) Module 4 |
| X60205 | 9-pin, Gray | Connector Engine control module II (DME) Module 5 |
| Pin | Type | Description / Signal type | Connection / Measuring notes |
|---|---|---|---|
| 1 | Not used | ||
| 2 | E | Programming voltage | Data link connector |
| 3 | E/A | Communication line data link TXD | Data link connector |
| 4 | M | Ground wire | Ground point |
| 5 | Not used | ||
| 6 | M | Control module ground | Ground point |
| 7 | E | Terminal 30 voltage supply | Fuse carrier, engine electronics |
| 8 | E | Terminal 87 | Terminal 87 splice |
| 9 | Not used | ||
| Pin | Type | Description / Signal type | Connection / Measuring notes |
|---|---|---|---|
| 1 | Not used | ||
| 2 | Not used | ||
| 3 | E/A | CAN bus low | Throttle position control module (EML) |
| 4 | E/A | CAN bus high | Throttle position control module (EML) |
| 5 | M | Shield, CAN-BUS | Throttle position control module (EML) |
| 6 | Not used | ||
| 7 | A | Oxygen sensor heater signal | Heated oxygen sensor II behind catalytic converter |
| 8 | M | Heated oxygen sensor ground | Shield for heated oxygen sensor II behind catalytic converter |
| 9 | M | Heated oxygen sensor ground | Heated oxygen sensor II in front of catalytic converter |
| 10 | M | Heated oxygen sensor ground | Shield for heated oxygen sensor II in front of catalytic converter |
| 11 | M | Heated oxygen sensor ground | Heated oxygen sensor II behind catalytic converter |
| 12 | Not used | ||
| 13 | Not used | ||
| 14 | Not used | ||
| 15 | E | Heated oxygen sensor signal | Heated oxygen sensor II in front of catalytic converter |
| 16 | Not used | ||
| 17 | E | Heated oxygen sensor signal | Heated oxygen sensor II behind catalytic converter |
| 18 | Not used | ||
| 19 | A | Oxygen sensor heater signal | Heated oxygen sensor II in front of catalytic converter |
| 20 | Not used | ||
| 21 | Not used | ||
| 22 | Not used | ||
| 23 | A | Terminal 85 control | Engine control module relay II |
| 24 | Not used | ||
| Pin | Type | Description / Signal type | Connection / Measuring notes |
|---|---|---|---|
| 1 | Not used | ||
| 2 | A | Injection signal | Cyl. 10 fuel injection valve |
| 3 | A | Signal Evaporative emission valve | Evaporative emission valve II |
| 4 | Not used | ||
| 5 | Not used | ||
| 6 | M | Ground for electronic components | Ground point |
| 7 | Not used | ||
| 8 | Not used | ||
| 9 | M | Hot-film mass air flow sensor ground | Hot-film mass air flow sensor |
| 10 | Not used | ||
| 11 | A | Signal, secondary air injection pump valve | Secondary air injection pump valve |
| 12 | Not used | ||
| 13 | Not used | ||
| 14 | A | Signal, changeover valve | Air-contained fuel injection valves, bank 2 |
| 15 | A | Injection signal | Cyl. 8 fuel injection valve |
| 16 | Not used | ||
| 17 | Not used | ||
| 18 | E | Inertia fuel shutoff switch signal | Throttle position control module (EML) |
| 19 | E | Control unit recognition | Ground point |
| 20 | E | Camshaft position sensor signal | Hall effect camshaft position sensor |
| 21 | Not used | ||
| 22 | Not used | ||
| 23 | E | Hot-film mass air flow sensor signal | Hot-film mass air flow sensor |
| 24 | Not used | ||
| 25 | Not used | ||
| 26 | Not used | ||
| 27 | A | Injection signal | Cyl. 12 fuel injection valve |
| 28 | A | Injection signal | Cyl. 11 fuel injection valve |
| 29 | Not used | ||
| 30 | Not used | ||
| 31 | Not used | ||
| 32 | E | Crankshaft position sensor signal | Crankshaft position/RPM sensor II |
| 33 | Not used | ||
| 34 | E | Intake air temperature | Intake air temperature sensor |
| 35 | Not used | ||
| 36 | E | Signal, sensor 4 | Knock sensor |
| 37 | M | Shield, knock sensor | Knock sensor |
| 38 | Not used | ||
| 39 | Not used | ||
| 40 | A | Injection signal | Cyl. 9 fuel injection valve |
| 41 | A | Injection signal | Cyl. 7 fuel injection valve |
| 42 | Not used | ||
| 43 | Not used | ||
| 44 | Not used | ||
| 45 | M | Ground | Shield up to 10 mm before crankshaft position/RPM sensor II |
| 46 | E | Crankshaft position sensor signal | Crankshaft position/RPM sensor II |
| 47 | M | Ground | Intake air temperature sensor |
| 48 | Not used | ||
| 49 | E | Sensor 3 signal | Knock sensor |
| 50 | M | Shield, knock sensor | Knock sensor |
| 51 | Not used | ||
| 52 | Not used | ||
| Pin | Type | Description / Signal type | Connection / Measuring notes |
|---|---|---|---|
| 1 | Not used | ||
| 2 | Not used | ||
| 3 | Not used | ||
| 4 | Not used | ||
| 5 | Not used | ||
| 6 | E | Start signal terminal 50 | Ignition switch |
| 7 | Not used | ||
| 8 | Not used | ||
| 9 | Not used | ||
| 10 | A | Activation of relay for fuel pump (EKP) | Fuel pump relay |
| 11 | Not used | ||
| 12 | Not used | ||
| 13 | Not used | ||
| 14 | Not used | ||
| 15 | Not used | ||
| 16 | Not used | ||
| 17 | A | Engine speed signal output (TD) | Data link connector |
| 18 | Not used | ||
| 19 | Not used | ||
| 20 | Not used | ||
| 21 | Not used | ||
| 22 | E | LH rear engine speed signal | ABS/DSC control module |
| 23 | Not used | ||
| 24 | Not used | ||
| 25 | Not used | ||
| 26 | E | Voltage supply, terminal 15 | Fuse F24 |
| 27 | Not used | ||
| 28 | Not used | ||
| 29 | E | Compressor ON signal from engine control module (DME) | Heating and A/C control module |
| 30 | Not used | ||
| 31 | Not used | ||
| 32 | Not used | ||
| 33 | E/A | Communication link (EWS) | Electronic drive-away protection control unit (EWS) |
| 34 | Not used | ||
| 35 | M | Shield, CAN-BUS | CAN star contact coupler |
| 36 | E/A | CAN bus high | CAN star contact coupler |
| 37 | E/A | CAN bus low | CAN star contact coupler |
| 38 | Not used | ||
| 39 | Not used | ||
| 40 | A | Start signal | Starter relay |
| Pin | Type | Description / Signal type | Connection / Measuring notes |
|---|---|---|---|
| 1 | E | Ignition current feedback | Cyl. 2 ignition coil |
| 2 | Not used | ||
| 3 | A | Terminal 1 signal | Cyl. 2 ignition coil |
| 4 | Not used | ||
| 5 | M | Ground | Ground point |
| 6 | A | Terminal 1 signal | Cyl. 2 ignition coil |
| 7 | Not used | ||
| 8 | Not used | ||
| 9 | A | Terminal 1 signal | Cyl. 2 ignition coil |