CCC - navigation

Car Communication Computer (CCC) navigation

In the test module ”CCC navigation”, the following connections / functions are tested.

• Diagnostic fault memory entries (after self-test and system test)
  
• HIP module
  
• Rotation rate sensor
  
• GPS antenna
  

Analysis of the diagnostic fault memory entries

In the test module ”CCC navigation”, the relevant diagnostic fault memory entries are analyzed and the corresponding fault remedy measures are displayed. Some faults are only entered in the memory when a self-test or system test is run. These tests are run automatically at the start of the test module.

Test of the HIP module

The HIP module is a component that can be replaced separately in the CCC.

In the test module ”CCC navigation”, a test is started to determine whether the HIP module is functional. The following points must be borne in mind during the diagnosis.

• Malfunctions can be remedied by briefly disconnecting the CCC from the voltage supply.
  
• After replacement of the HIP module, the vehicle must be driven for at least 15 minutes with good GPS reception to find the current position. During this calibration, no location display is possible.
  

Test of the rotation rate sensor and GPS antenna

The rotation rate sensor is a component that can be replaced separately in the CCC.

If there is a problem with the HIP module, problems also occur with the rotation rate sensor and GPS antenna, as these are connected internally with the HIP module.