Repair instructions for 'retainer of middle roof shell towards rear roof shell'

Retainer of middle roof shell towards rear roof shell

Adjust the mounting for the locking pin of the middle roof shell towards the rear roof shell.

Mounting for locking pin

Important note!

On loosening and tightening the bolts, attention must be paid to ensuring that the mounting is not twisted.

1. Carefully loosen the bolt (A) from the mounting
   
2. Adjust the mounting.
   The axis of the roller (C) may be adjusted upwards by a maximum of 1 mm.
   
3. The center of rotation of the mounting during calibration is bolt (B). Do not loosen this bolt!
   
4. Carefully tighten bolt (A).
   
5. Check the closing characteristics and protrusion of the middle roof shell towards the rear roof shell; if necessary, repeat the setting.