Setting the centre fastening

Repair instruction for setting the centre fastening

Vehicle production date up to calendar week 31/2007

  1. Remove the headlining of the front roof shell.
  2. Loosen the two screws (2) and (3). See Fig. 1.
    Note:
    do not loosen screw (1).
  3. Turn the fastener until the setting value of 12 - 14 mm is reached. See Fig. 2.

Image 1

GR_FB5407025

The rear right-hand screw (1) must not be opened.

Loosen the two front screws (2) and (3). Turn the centre fastening clockwise forwards until the setting value of 12 - 14 mm as shown in Fig. 2 is reached.

Image 2

GR_FB5407026

Place the tape measure at the thickest point on the outside of the roller and set a value of 12 - 14 mm up to the end of the heel.