Moulded corner on rear module seal deformed

Repair instruction for 'moulded corner on the rear module seal deformed'

Check that the rear module seal in the area of the moulded corner, see Fig. 1, has the correct shape.

  1. The gap between the sealing lip and the edge must be 11 mm. See Fig. 2.
  2. If the gap is too small, see Fig. 3, correct the gap by pulling the sealing lip.

Note

If possible, do not take the seal off the flange, as this damages the sealing compound underneath. If removal (opening the screw connection) is necessary, attention must be paid to ensuring that the sealing compound is repaired as otherwise new leaks can occur.

Image 1

GR_FB5407063

Moulded corner on the rear module seal.

Image 2

GR_FB5407065

Target status:

The gap (3) between the sealing lip (1) and the edge (2) must be 11 mm.

Image 3

GR_FB5407064

Fault status:

The gap between the sealing lip (1) and edge (2) is too small. Correct the gap by pulling the sealing lip (1) outwards.